The Ford Barn

The Ford Barn (https://www.fordbarn.com/forum/index.php)
-   Early V8 (1932-53) (https://www.fordbarn.com/forum/forumdisplay.php?f=4)
-   -   water pumps (https://www.fordbarn.com/forum/showthread.php?t=115857)

rer_239 08-28-2013 08:45 AM

water pumps
 

My 8ba has an annoying squeal. Took off tthe fan belt. And on pump has a slight noise when spinning by hand. Bad pump?

37 Coupe 08-28-2013 09:34 AM

Re: water pumps
 

Probably a bad bearing that the later pumps used.

rer_239 08-28-2013 09:51 AM

Re: water pumps
 

any fix to it? or just replace?

37 Coupe 08-28-2013 10:50 AM

Re: water pumps
 

I have not had a later engine or that type of water pump for over twenty years. I assume it is a ball bearing pump and if it is it should be a sealed bearing and probably should be removed to repair or to replace.

19Fordy 08-28-2013 11:22 AM

Re: water pumps
 

rer 239, You will find this article on how to repair your pump very helpful.
http://www.flatheadv8.org/Waterpump/pump.htm

52fordv8 08-28-2013 12:43 PM

Re: water pumps
 

nice thread im getting ready to rebuild a set of 52 car narrow pulley pumps . . how can u tell if there off the engine if there any good as they are . or do u just rebuild them when there off to be safe ???

rer_239 08-28-2013 01:01 PM

Re: water pumps
 

i was running one belt from the double engine pulley to both pumps and on up to the alternator. switched to 2 belts one to the pumps and another to the alternator. end of squeal.

thanks
guys

Walt Dupont--Me. 08-28-2013 02:22 PM

Re: water pumps
 

A little story about a pump squeal. One of those engine I just posted the 59 block. The owner bought a couple of so called rebuilt pumps at a flea market. I installed them and started the engine on the test stand. I never heard such a squeal in my life, it sounded like 500# pig hanging up by his rear legs getting ready to be slotered. you have to be brought up on a farm to understand that. I had to start it 2-3 times to find out where the noise came from, It was one of the pumps, I don't think they reamed the bushings enough when they installed them. Both pumps are at Skips now being done right. Walt


All times are GMT -5. The time now is 11:20 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.