The Ford Barn - '29 Running Board Measurement Sought

The Ford Barn (https://www.fordbarn.com/forum/index.php)

- Model A (1928-31) (https://www.fordbarn.com/forum/forumdisplay.php?f=3)

- - '29 Running Board Measurement Sought (https://www.fordbarn.com/forum/showthread.php?t=108450)

ericr

06-08-2013 11:34 AM

'29 Running Board Measurement Sought

I can't get one repo running board to align with the holes in the braces mounted to the frame. Either the braces are pushed in, or the bolt brackets spot-welded on the bottom of the board are located incorrectly.
Does anyone have a measurement from the center of any of the bell-shaped mounting bolts to the edge of the running board trim?

chuckstinn

06-08-2013 12:54 PM

Re: '29 Running Board Measurement Sought

I measured 1-1/16 inches from the outer edge of the running board (with trim installed) to the center of the square hole where the bell head bolt goes.

ericr

06-08-2013 01:20 PM

Re: '29 Running Board Measurement Sought

Quote:

Originally Posted by chuckstinn (Post 667174)

I measured 1-1/16 inches from the outer edge of the running board (with trim installed) to the center of the square hole where the bell head bolt goes.

Thanks Chuck!

Steve Plucker

06-08-2013 02:09 PM

Re: '29 Running Board Measurement Sought

Quote:

Originally Posted by ericr (Post 667133)

Welcome to the world of "repro" parts...I would of sent them back and got in touch with Bert's in Denver and got some original ones.

But that is just me (and a few others I know).

Pluck

All times are GMT -5. The time now is 11:44 AM.