'32 BB cab mounting bolts Howdy boys, I just put the cab on the '32 BB I've been working on for WAY too long, but I have forgotten where the bolts with the coil springs go? Yup, I took lots of pictures but not of this of course. Any help would be appreciated! Pictures of course, would be nice! Thanks guys!
|
Re: '32 BB cab mounting bolts Bolts with coil springs are used to mount the gas tank in cab.
|
Re: '32 BB cab mounting bolts They are too long for the tank. There was only one bolt on the tank with a coil spring, 3/8" if I remember correctly. The ones I have, that I believe came off of the cab, since they were in the can marked "cab bolts" are 7/16", have a washer, coil spring, and castle nut. The bolts are about 3.5-4" long.
|
Re: '32 BB cab mounting bolts Back of the cab.
|
Re: '32 BB cab mounting bolts Cool 33, so how do they mount? They are 7/16 bolts, but the holes are 3/8. Pictures would tell the story. Thanks.
|
Re: '32 BB cab mounting bolts totto, so now I'm curious. There was only one bolt on the tank that had a spring. The other two did not. Are they all supposed to have a coil spring? Thanks.
|
Re: '32 BB cab mounting bolts No, just one in the center hole on one side and two 3/8"-24 hex head bolts without springs on the opposite side.
|
Re: '32 BB cab mounting bolts I looked at my original 33 BB and they go thru from inside the cab and the spring, washer and nut go underneath in the frame. Mine look to be 3/8 where the nut goes on but can't see the whole length. If it were mine and they go thru the frame holes ok, I would just enlarge the holes in the cab floor.
|
Re: '32 BB cab mounting bolts David: THANKS for your input!
|
Re: '32 BB cab mounting bolts Thanks Cool 33. You were the first to correctly provide an answer. I just wanted to make sure. Thanks again!
|
Re: '32 BB cab mounting bolts deleted
|
Re: '32 BB cab mounting bolts Hey David G, this truck, which is an AAB does have the coil springs on the rear cab bolts. They are 7/16", about 3.5" long. Sugarmaker sent me some pictures of his, which is also an AAB. Thanks.
|
Re: '32 BB cab mounting bolts Folks,
I took these pictures of the cab mounts on our AAB 32 truck. in the rear there is the spring and nut on the bottom of the frame as Cool 33 describes. https://i.postimg.cc/sgQKbZF4/IMG-20...-150421321.jpg But on the front of the cab there is no spring https://i.postimg.cc/SNZtBhnk/IMG-20...-150228824.jpg Regards, Chris and Cheryl |
All times are GMT -5. The time now is 04:01 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.