34 front engine mount /water outlet
 

Are there any suppliers of new castings for the front enginemount / water outlet for 34 engine mine have both corroded away , thanks in advance

Re: 34 front engine mount /water outlet
 

Not reproduced to my knowledge.The Ford Store in San Dimas,CA might have a nice original pair available.Maybe a member here also.

Re: 34 front engine mount /water outlet
 

I have a pair but they are not marked ! I thought they were 35 when I bought them but they were too Narrow when mounted on my engine so maybe ethey are 34/34, You are wlecome to have them for the 35 dollars I have in them plus the S&H cost.. They are useable but have some rust at the outlets. kerk

Re: 34 front engine mount /water outlet
 

Phil,
I have some....they are originals. I machine off the rotted water snout and
and counter bore into the now solid iron. I renew the proper length snout with an iron sleeve that is step turned and pressed into the orig casting. In addition to the press fit on the sleeve I use JB long setting epoxy. No issues, some Barners are using them. I
would certainly welcome any comment either way.
Charlie ny
[email protected]

Re: 34 front engine mount /water outlet
 

Charlie's repair is GOOD.
I also have a pair that are available. Some rust-out on ends, but still usable. They have the part # cast on.

Re: 34 front engine mount /water outlet
 

Thanks Charlie , me being a machinist i will do the same to mine , thanks for the info cheers Phil

Re: 34 front engine mount /water outlet
 

I recommend one additional step after the repairs have been completed, namely powder coating inside and out. If your powder coating source doesn't have the Ford engine green color you can always add that over the powder coating with a rattle can.