Picture of a tailpipe bracket 39 Does anyone have a picture of how the last (rear) tailpipe bracket goes on a 39 pickup? I got a new bracket but I am not sure where it goes.
|
Re: Picture of a tailpipe bracket 39 I don't have a picture but it go's up through a hole in the small cross over above the exhaust pipe. G.M.
|
Re: Picture of a tailpipe bracket 39 1 Attachment(s)
The final exhaust clamp 99A-5261 is the same for 39 85 HP pick up and passenger and 40 85 HP pick up and passenger. I am not aware of anyone making a reproduction of this bracket. It is one piece, the clamp (angled) is welded to a short round rod that extends into a round rubber block and is vulcanized to the rubber, coming out of the rubber, on the opposite side, is another round rod that is again vulcanized into the rubber and threaded at the final end. The threaded end of this rod is inserted into a hole in the frame and held to the frame by a lock washer and nut, the angled clamp hangs down and accepts the tail pipe.
|
Re: Picture of a tailpipe bracket 39 The rubber section is famous for splitting in the middle.
|
Re: Picture of a tailpipe bracket 39 2 Attachment(s)
Quote:
I just looked at Mac's and they have this one Mine looks like the second picture, So its the front? where does it go? |
Re: Picture of a tailpipe bracket 39 The drawing with the rectangular block of rubber is 41 and not 39, the photo is 39-40 style.
|
All times are GMT -5. The time now is 12:10 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.