The Ford Barn

The Ford Barn (https://www.fordbarn.com/forum/index.php)
-   Model A (1928-31) (https://www.fordbarn.com/forum/forumdisplay.php?f=3)
-   -   Window riser handle question (https://www.fordbarn.com/forum/showthread.php?t=240947)

wrndln 03-16-2018 05:20 PM

Window riser handle question
 

1 Attachment(s)
I have an original window riser handle that had the knob frozen to the main part. Thanks to Dick Crabtree, he told me to soak the knob in Lock-Ease for a while. I did. With some leather to protect the knob, after 3 weeks soaking the knob in the Lock-Ease, the knob broke loose with a ViceGrip clamped around the protective leather. I can now turn the knob, but it is still stiff. I am afraid that when I get the handle replated, the nickel plating might cause the knob to freeze up again. What I would like to find is some thin liquid abrasive that I could dip the knob in or put a few drops in the narrow crack that would "grind" open the very narrow space between the main part of the handle and the knob. Like I mentioned, the space is quite narrow, so any thick liquid wouldn't flow into the space.
Thanks for any helpful suggestions.
Rusty Nelson

Tacoma Bob 03-16-2018 11:27 PM

Re: Window riser handle question
 

mmmmm Not sure it can be plated without removing the knob.

jw hash 03-17-2018 10:13 PM

Re: Window riser handle question
 

if you want a good plating job. you need to remove the knob. Rusty I can send you some pictures of the tools I made to remove the knobs. 31avicky@comcast.net
John


All times are GMT -5. The time now is 05:41 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.