Marvel Schebler float depth ? Was wondering how to set the float level on the Marvel Schebler carb ?
Thanks for any info Jon in Ohio |
Re: Marvel Schebler float depth ? Not sure, but when mine gets back from:
http://rennerscorner.com/index.html PM me and I'll pull the float measurement for you! |
Re: Marvel Schebler float depth ? Hi Jon
Maybe some of the information in this post will help you. https://www.fordbarn.com/forum/showthread.php?t=139836 Jeff |
Re: Marvel Schebler float depth ? Thanks Jeff - you answered my question in your MS thread:
Quoting Jeff from his well written MS thread: "Service Note: Setting float height, the float should be parallel to the upper gasket surface. I used the float seam to gasket surface (15/16"). In the photo it looks a little off but this is camera distortion. If measured as shown the clearance between the gasket surface and the top of the float is 1/4". The height from the gasket surface to the bottom of the float is 1 3/4". |
All times are GMT -5. The time now is 03:11 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.