body blocks and frame webbing my 29 cc AA has the body blocks, is there supposed be any frame webbing or anti squeak, between the blocks and the frame and sub frame? thanks
|
Re: body blocks and frame webbing Just between the frame and fender/splash aprons.
Pluck |
Re: body blocks and frame webbing And rubber tacked onto the bottom of the block in the frame contact area. Any shimming would be additional rubber held in place by the bolts passing through a hole in shim.
|
Re: body blocks and frame webbing 3 Attachment(s)
Here are some photos of body blocks. The rubber on the block goes down against the top of the splash apron. The splash apron is sitting on the frame webbing, the frame webbing runs from the front of the frame along the frame to the end of the splash apron and ends.
You can read more about the frame welting "anti-squeek" here on Plucks website - http://www.plucks329s.org/pdf/studie...EAKARTICLE.pdf |
Re: body blocks and frame webbing 1 Attachment(s)
Quote:
For the AA with 82-A closed cab, the anti-squeak (frame webbing) runs under the front fenders and running board shields to where the shields leave the frame. In the attached, I ran the welt a little further and put welt on the body bracket to make it level with the frame. There are rubber pads under the cowl sides where the front body blocks are. The other body blocks have a rubber pad attached to the block (between the frame and block). No pad or webbing on the top side of body blocks. Use pads reinforced with webbing (otherwise, plain rubber pads will just compress down to nothing). |
All times are GMT -5. The time now is 03:08 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.