1936 gas guage My dash gas gage is not reading at all... have power at the gage and power at the wire to tank sender. There is a 1/4 tank of gas.
It had been working and then noticed it was not. Is there a way to test the dash gage out of the car ? This is an original 36 gage. If the dash gage test bad, where do I send it for repair ? |
Re: 1936 gas guage 1 Attachment(s)
This pic from a 12/2012 thread shows us using a battery and a sender to go through the gauge in the cardboard box to make the needle move.
https://www.fordbarn.com/forum/attac...8&d=1591758442 |
Re: 1936 gas guage Take the gauge out.Remove the speedo will make it easier.I use a 9V smoke detector batt and wires with alligator clips.Call John Wolf & Co in OH about repair if necessary.There is a member that has a couple of those NOS $165 ea.
|
Re: 1936 gas guage Thank you both for the info....
DEUCE LOVER...I tested the gage as you suggested and the gage worked. So I thank you for that. I will now look at the sender itself... |
Re: 1936 gas guage 1 Attachment(s)
Quote:
|
Re: 1936 gas guage Thanks JSeery I will look into that...
|
Re: 1936 gas guage Loose ground wire...problem solved
I did learn a lot with help from you guys...thanks |
Re: 1936 gas guage Thanks for the feed back.
|
All times are GMT -5. The time now is 04:26 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.