1929 open car wind wings
 

I have a 29 phaeton with reproduction wind wings . I have a left side original set that need to be replated and I am in search of a set for,the passenger side. Does anyone one know if I could get a correct looking bolt and get rid of the a corn bolts while I am in search and going to get the original ones plated when I get all of the proper parts any and all information is appreciated thanks so much Joe.

Re: 1929 open car wind wings
 

Fabricate it on a lathe.

Re: 1929 open car wind wings
 

Brent,thanks for responding to my question,please bear with me are you suggesting that I have a bolt lathe and would your shop make them? What I believe I have is a thread stud that goes into the bracket and the acorn nut on the outside to hold in place ? I am hoping to one day have a complete restored set to put on my car one day I thought I saw someone had got a proper looking bolt and replaced the stud with the bolt . What I am wondering is this poo what size and thread and where I might purchase them if a lathe is the only way I am very interested thank you so much for the y Joe

Re: 1929 open car wind wings
 

Still looking for help ! Please help if you can

Re: 1929 open car wind wings
 

Is this the bolt on Val and Mark Maron's Roadster you are asking about?


Bob

Re: 1929 open car wind wings
 

Here is a copy of the original print. Here are the dimensions. Supposed to be Nickel plated.


.
.

Re: 1929 open car wind wings
 

Thanks so much guys I can work with this information! I am so grateful to both of you Brent and Bob .

Re: 1929 open car wind wings
 

The info came from your State. Go visit the library sometime and you will likely be hooked.