Radiator shroud fit question Has anyone had experience with installing the ‘28 shroud (original) with a reproduction radiator? The radiator in my 28 appears to be the low price version available from Mac’s. I’ve done a bunch of measuring and looks like the bottom tabs on the radiator are in the way- I’m curious if the tabs on an original or a Brassworks show quality radiator are in a different spot or orientation?
Thanks! |
Re: Radiator shroud fit question It’s been a while, but it was difficult aligning the shroud tabs on my radiator. I don’t know what brand the radiator is, but I gave up in the end and used black zip ties at the bottom.
|
Re: Radiator shroud fit question The radiator had been replaced on my ‘28 Sport Coupe. I bought a new outer shroud. I had to trim (cut) the lower section a little bit adjusting it to fit in further- closer to the radiator, grind a small piece of each side of the lower radiator brackets and redrill the four mounting bolt holes. I still have not permanently mounted it back on again - I’m doing a complete body off. Things have pretty much stopped right now.
Dave |
Re: Radiator shroud fit question Opps... l was refusing to the outer radiator chrome cover.
|
Re: Radiator shroud fit question The Brassworks uses and OE shell for test fitment on the 28. If you have a shell and would like it test fit to the radiator being built you would need to ship it in. It can travel back in the same box as the radiator
|
All times are GMT -5. The time now is 08:09 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.