Might have screwed up Not sure but I may have screwed up . I removed my crankshaft pulley nut with my air impact gun. After I did, I got to wondering if I may have damaged the rod bearings. I did not rattle on it very long before it came out but now I am concerned. Should I be?
|
Re: Might have screwed up I doubt that you hurt anything.:)
|
Re: Might have screwed up I doubt that you hurt anything.
The crank has a lot of mass to it and the rod bearings will be fine. If the flywheel was still attached to the crank, the rod bearings would not even know something was going on. My opinion, Chris W. |
Re: Might have screwed up Thanks fellas
|
All times are GMT -5. The time now is 06:25 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.