Rotor discrepancy on 8ba flathead V8 I have a 239 ci 8ba v8 flathead I went to change the rotor on a tuneup and discovered that the rotor was larger than the distributor shaft! Someone took a beer can and cut a small piece of it to take up the slack ! Of course this meant it would run for a while and then just quit! After a few minutes it would start again! Has anyone else run into this problem? I am at the point that I will buy an Electronic ignition distributor to fix this . What is the best distributor to buy for a 1949 to 1953 Ford 8ba flathead v8? Or can I buy the right rotor?
|
Re: Rotor discrepancy on 8ba flathead V8 Welcome to fordbarn. You placed your question in a forum intended for questions "To The Editors". Few people read this forum and even fewer respond. Leave your question here but also place it here: https://www.fordbarn.com/forum/forumdisplay.php?f=4
Sorry I don't know the answer to your question, if I did I would post it. Charlie Stephens |
All times are GMT -5. The time now is 03:25 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.