Pertronix 1285LS Crab conversion Hi Guys,
I am interested in reading more about these 1285LS conversion modules for the crab distributor. I searched on here and not much has been posted for a couple of years. My set up is 12volt neg earth and alternator. Stock 59A . There was some discussion about needing 1.5 ohm Coil and 1.5 ohm resistor, but some disagreed with the need for the resistor. What is the latest suggestion for these units? thanks, Dave |
Re: Pertronix 1285LS Crab conversion What does Pertronix specify?
Bob |
Re: Pertronix 1285LS Crab conversion Pertronix recommends full 12 volts to the Pertronix trigger unit.
Use a 1.5 ohm 12 volt coil. |
Re: Pertronix 1285LS Crab conversion Quote:
Yep ,and i would suggest using a NAPA IC12SB coil......... |
Re: Pertronix 1285LS Crab conversion Great thanks guys,
some of the earlier posts were misleading (back in 2013). It appears to be an easy conversion. Dave h |
Re: Pertronix 1285LS Crab conversion Check for excessive wear in the bushings. The original shops that did these conversions (Jerry Jobe & Mickey Remund) would install new bushings and line ream them. I suspect that's why these units didn't have a lot of the problems that later do it your self ones had.
|
All times are GMT -5. The time now is 04:38 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.