The Ford Barn

The Ford Barn (https://www.fordbarn.com/forum/index.php)
-   Model A (1928-31) (https://www.fordbarn.com/forum/forumdisplay.php?f=3)
-   -   Marvel Schebler float depth ? (https://www.fordbarn.com/forum/showthread.php?t=175266)

Jon-Ohio 08-08-2015 01:02 PM

Marvel Schebler float depth ?
 

Was wondering how to set the float level on the Marvel Schebler carb ?

Thanks for any info

Jon in Ohio

roccaas 08-08-2015 02:37 PM

Re: Marvel Schebler float depth ?
 

Not sure, but when mine gets back from:

http://rennerscorner.com/index.html

PM me and I'll pull the float measurement for you!

Jeff in BC 08-08-2015 02:46 PM

Re: Marvel Schebler float depth ?
 

Hi Jon
Maybe some of the information in this post will help you.
https://www.fordbarn.com/forum/showthread.php?t=139836

Jeff

Jon-Ohio 08-08-2015 03:23 PM

Re: Marvel Schebler float depth ?
 

Thanks Jeff - you answered my question in your MS thread:

Quoting Jeff from his well written MS thread:

"Service Note: Setting float height, the float should be parallel to the upper gasket surface. I used the float seam to gasket surface (15/16"). In the photo it looks a little off but this is camera distortion. If measured as shown the clearance between the gasket surface and the top of the float is 1/4". The height from the gasket surface to the bottom of the float is 1 3/4".


All times are GMT -5. The time now is 04:20 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.