Crab type cap on 59-A distributor Can you put a crab type cap on a 59-A distributor. It is the 2bolt type with the 2 piece cap, it is very hard to feed the wires through this cap and get it back together. Do you change the rotor, and what about the spring wire that swings over to hold the cap in place. Do you keep this wire, or is there something else that holds the crab cap on? Thanks, Jack
|
Re: Crab type cap on 59-A distributor Yes, I got the cap, rotor and clips from Mac Van Pelt. Just finished it today.
Bill |
Re: Crab type cap on 59-A distributor As Bill says, just change the cap and the retaining clips:
21A-12106 cap (with brass contacts)........... $22.50 21A-12144S clip & pin kit........................... $ 6.00 21A-12200 rotor..................................... $ 9.50 We keep them in stock. |
Re: Crab type cap on 59-A distributor You must change the rotor also to go with the crab cap. Walt
|
Re: Crab type cap on 59-A distributor Jack, I'm going to PM you my phone number. I live around the corner from you in Santee. Give me a call and we can chat.
|
All times are GMT -5. The time now is 05:53 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.