55 crown Victoria hel0 needed 1 Attachment(s)
Im looking for help to ID a part. Im restoring a 55 ford crown Victoria and looking for a small exterior door trim piece. However i do not even know what it would be called let alone the fomoco part number or where to find it.
The piece is about 2×2inches and is just outside the door lock knob on the ext. door panel (below the side 'crown pillar' on the roof. Picture attached. Thanks in advance for any info u can provide. |
Re: 55 crown Victoria hel0 needed 1 Attachment(s)
Quote:
|
Re: 55 crown Victoria hel0 needed I have seen those in an ad. Reproduction part. Don't remember where since I didn't need them. Pretty pricey. If I can find the ad or the supplier I will post it.
Ben |
Re: 55 crown Victoria hel0 needed The part # for the left/driver side is B5A-6420189-A. It's called door outside rear upper corner molding.
Fits '55-'56 Crowns, Body style 64A and 64B (glass top & steel top). Maybe try searching by part number for a possible source. |
Re: 55 crown Victoria hel0 needed Quote:
:confused: Now, how did you do that? |
Re: 55 crown Victoria hel0 needed If anyone comes across the emblem, please post a photo here.
|
Re: 55 crown Victoria hel0 needed Quote:
I found the door outside rear upper corner molding but the numbers I have are B5A 6421088/89 A |
Re: 55 crown Victoria hel0 needed Quote:
88 will be RS and 89 LS. |
Re: 55 crown Victoria hel0 needed Quote:
|
Re: 55 crown Victoria hel0 needed Quote:
It's in the old Ford parts book that I have. Exterior moldings section for '55s. Not to worry though, as an old parts guy from many years ago, I've had my share of being stumped when trying to find some things. |
Re: 55 crown Victoria hel0 needed Quote:
|
Re: 55 crown Victoria hel0 needed Quote:
|
Re: 55 crown Victoria hel0 needed Quote:
He sank my battleship ... :( |
Re: 55 crown Victoria hel0 needed https://www.fordbarn.com/forum/attac...p;d=1571548878
Here is a close up picture of that elusive small Trim Piece on the door, unique to the 1955 Ford Crown Victoria. |
Re: 55 crown Victoria hel0 needed Quote:
Thanx! ... :D |
Re: 55 crown Victoria hel0 needed |
Re: 55 crown Victoria hel0 needed I looked at the EBAY auction. Some people are crazy. I would rather make one out of steel and have it chrome plated, than pay $600 for a pair. Plus they are reproductions. Not even original. Greed really prevails here.
Sal |
Re: 55 crown Victoria hel0 needed Quote:
|
Re: 55 crown Victoria hel0 needed Quote:
|
Re: 55 crown Victoria hel0 needed Don't use steel use brass. Easier to carve and drill for pin and the screw and brasss loves Chrome...
Some of the prices for this old car stuff is really beyond belief! And repros to boot! Hope they put them in this guy's coffin... |
All times are GMT -5. The time now is 10:54 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.