License Plate Clamp Orientation 1 Attachment(s)
Which part goes on the license plate side and which on the radiator side?
|
Re: License Plate Clamp Orientation 1 Attachment(s)
looking down from top of light bar,I put rubber washers to protect plate
|
Re: License Plate Clamp Orientation 1 Attachment(s)
Not really sure of your question, here is a picture of Marco's Roadster.
Bob |
Re: License Plate Clamp Orientation Quote:
|
Re: License Plate Clamp Orientation According to the Standards and parts book both halves of the clamp are the
same if that is what you are asking. A-13145 front license clip 4 required. Bob |
Re: License Plate Clamp Orientation The clamps in your photo are not Model A clamps.
|
Re: License Plate Clamp Orientation 1 Attachment(s)
License clips RG&JS 18-3 Revised 2011
|
Re: License Plate Clamp Orientation looking at the pictures and reading the text. the pictures show the bolts installed from the front of the head light bar and the text say the bolts are installed from the radiator side. so what do you go by?
|
Re: License Plate Clamp Orientation 1 Attachment(s)
Here is RG&JS 18-4 Revised 1997 showing the incorrect installation of license plate clips.
Go figure ???? |
Re: License Plate Clamp Orientation Install them as Gary and Marco show, with the bolts above the headlight bar.
The 1928-9 clamps are a bit different, and have the bolts below the bar. |
All times are GMT -5. The time now is 09:36 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.