34 wire harness Good day folks, can anyone tell me what the proper routing would be for the cross over wire to run dual tail lights on a 34? Also anyone know where I could find the harness clips that hold it secure to the frame, I have some from Macs but there about a 1/4 inch too long. Ken
|
Re: 34 wire harness The tail lamp crossover wire was clipped to the back lip on the fuel tank. You might try A&L Parts Specialties in Canton, CT for the short clips.
|
Re: 34 wire harness 1 Attachment(s)
Not original I guess, but I clipped mine along the rear edge of the crossmember. I just didn’t feel good about attaching electrical wiring to a fuel tank....
|
Re: 34 wire harness Quote:
|
Re: 34 wire harness Both short and long clips were made. You will need the short one for the edge of the tank, total of three.
|
Re: 34 wire harness Quote:
|
Re: 34 wire harness And just to make you more uncomfortable, aircraft have the pump wiring inside the tanks! :)
|
Re: 34 wire harness Quote:
|
Re: 34 wire harness Thanks ALL. Dave I will try A+L tomorrow. Ken
|
Re: 34 wire harness I think they're closed on Mondays. They have no web site.
Paul in CT |
Re: 34 wire harness Quote:
|
Re: 34 wire harness I stripped a few HQ Holden’s over the years,they gave up a pile of little clips and things,the clips are the ones I used on The 33 to clip the wiring and wires along the chassis’s,not completely original,but very close,and available from most junk yard cars
Lawrie |
All times are GMT -5. The time now is 08:55 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.