Removal of Oil Pump Idler Gear Shaft I am trying to remove the oil pump idler gear shaft. How is this done? I see the idler gear shaft is drilled and tapped, Do we thread a bolt into the shaft and use a pull handle to remove? HELP!!!!
|
Re: Removal of Oil Pump Idler Gear Shaft A slide hammer with a 3/8 course stud in the end will clunk it right out. Walt
|
Re: Removal of Oil Pump Idler Gear Shaft Put a short piece of pipe over the idler shaft,then get a bolt to match threads in shaft.Screw the nut up the bolt,and with a couple washers under nut,turn the nut down & it will pull the shaft out.
|
All times are GMT -5. The time now is 08:07 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.