(GAV) no response I just rebuilt the zenith and it runs and idles well. I tried to adjust and even closed the gav and nothing changed at all. I do not have a screw in seat for the gav. I am going to check and make sure it is bottoming out and adjust if need be but is there anything else I need to look for? Like I said, it runs great so I don't want cause problems.
|
Re: (GAV) no response running an air cleaner? made sure all passages in body are open? are you sure it doesn't require a seat?
|
Re: (GAV) no response Quote:
It's possible I'll have to do some grinding on parts of the gav needle to get it to go deeper. I saw a post of this being done and it seems simple enough |
Re: (GAV) no response Quote:
Sounding like a Model B carburetor. The internal threaded GAV bushing is "pressed" in to the body and there was a spring and washer underneath it? Joe K |
Re: (GAV) no response Quote:
Do you have a link to that post? Mine has a sizeable step in it. |
Re: (GAV) no response Quote:
Joe, my carb says zenith 2 on the side. |
Re: (GAV) no response Quote:
|
All times are GMT -5. The time now is 09:31 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.