Intake manifold ID... 1 Attachment(s)
Anyone know what year this aluminum Ford intake would be?
|
Re: Intake manifold ID... Looks like a '38 or '39 standard, but not sure about that round logo. Look on the underside for a date of manufacture. If it is Ford, it would be the imprint from a date tag tacked onto the mold.
|
Re: Intake manifold ID... Late 35 or 36, going by the 'high' generator mounting....
|
Re: Intake manifold ID... Tag on the underside is 6-3.... I want to use it on a '36 passenger car...
|
Re: Intake manifold ID... That is a '35 intake. I have the identical intake on both early and late model year original '35 passenger cars. Definitely not '36, '38 or '39.
It would work fine on a '36 engine but would not be show correct...IF...recognized by judges who knew the difference. |
Re: Intake manifold ID... JM35 is correct. '36 intake is similar, but is larger without indentations in the center area under the carburetor
|
Re: Intake manifold ID... Thanks guys. I am just concerned about the generator mounted fan being in the right location. Don't have the engine mounted yet to check clearance...
|
Re: Intake manifold ID... The bolt to mount the generator would be at 3". the later engines 37-39 the bolt to mount gen plate would be 2".
|
Re: Intake manifold ID... 8 Attachment(s)
These pictures may help in identifying some of the early Ford V8 aluminum intakes. I guess if they were cleaner, bead blasted, and pictures taken with better lighting it might be easier to see the differences.
|
Re: Intake manifold ID... My bad. John is right. Everyone is right but me. So ashamed. :( I'll be in the closet if you need me. :o With the light off.
|
Re: Intake manifold ID... JM 35 , thanks for posting all the info. Very helpful to me and others ....
|
Re: Intake manifold ID... I have an aluminum manifold with an S in a circle. Any ideas on that?
|
Re: Intake manifold ID... An old standard motor products manifold. Have lots of those in n.o.s. box's.
|
Re: Intake manifold ID... Ah, learn sumtin' new everyday. Thanks! It's slated for a 2 carb project I plan to do this winter.
|
Re: Intake manifold ID... 2 Attachment(s)
John,
There's one more late '34/early '35 intake manifold shown below. It's just like a typical '35 except it has a high rise fuel pump stand mounting surface like the smooth 40-5520-B manifold, also shown. The part number cast in the bottom of the manifold is 40-5520-B2 (a number at the end of suffix indicating an additional design/source). |
Re: Intake manifold ID... David, thanks for posting this picture of another version of late '34/early '35 intake manifold. The '34/early'35 in the picture I posted here is exactly like the one you show on the left. I have never seen one like you show on the right with the higher mount for fuel pump/breather stand. After seeing the post by Walt Dupont on his '35 engine build I wanted to come back to this post to look at pictures again.
|
All times are GMT -5. The time now is 07:58 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.