Pressure Test Plate Patterns/Drawings 1 Attachment(s)
Does anyone have the drawings or files for, say, a 59a style head gasket and water pump? I'm not wanting to make gaskets, I may have access to a water jet and would like to maybe have some pressure testing plates cut out. I don't have access to good drawing software any longer....
|
Re: Pressure Test Plate Patterns/Drawings Can you use a head gasket & water pump gasket for a pattern?
|
Re: Pressure Test Plate Patterns/Drawings Quote:
1- Get some used or new gaskets for patterns. 2- Rub trace the areas to paper. Make sure the paper is fastened tight so it doesn't move during rubbing. 3- Try some of the free drawing programs available for download. I have not used this one but it looks like it might work. http://www.inkscape.org/en/ While you are machining the head plate you can install holes for installing dowel pins to locate heads. |
Re: Pressure Test Plate Patterns/Drawings Pete, where is the best general location for the pins?
|
Re: Pressure Test Plate Patterns/Drawings I've been using QCAD it seems pretty good.
|
Re: Pressure Test Plate Patterns/Drawings 2 Attachment(s)
Quote:
We use our honing plate as the template to locate the holes. We drill the block holes with a letter "D" drill and the head and gasket holes .250". Began doing this procedure about 20 years or so back! Thanks, Gary in N.Y. P.S. Wishing all here a very Happy New Year! |
Re: Pressure Test Plate Patterns/Drawings Quote:
|
All times are GMT -5. The time now is 02:03 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.