Model B trans in model A chassis Hello all,
Does anyone still produce the float a motor style mounts for putting a B transmission into a model A. I plan on using an A engine. The mounts attached where the steady rod mounts originally went on the B flywheel cover. I think there was a mating component that attached to the frame. Thanks, Scott |
Re: Model B trans in model A chassis Jim Gordon in Rosmead CA used to make them. I do not know if he still does. He was on Garvey St.
|
Re: Model B trans in model A chassis Thanks, I looked him up and will try to call him
Scott |
Re: Model B trans in model A chassis He is also known as Ford Obsolete if memory serves.
|
Re: Model B trans in model A chassis Here is the contact info for: Jim Gordon (Specialty Ford Parts) -DIV. Antique Auto Parts-9101 East Garvey Ave, Dept. CL Rosemead,California 91770....(626)288-2121 (626) 280-4546....Catalog yes: Call. 4 cyl and V8...A very...very good source for most anything Stromberg/Holly...Plus so much more...Good Luck... (Float O Motor)
|
Re: Model B trans in model A chassis Thought I would share my experience. I tried calling Jim several times to no avail. I called Burts Model A looking for the same parts and he said that Jim was the guy that made them but he hadnt been able to get in touch with him for about a year and a half. He said he had tried phone, email and letters. So here's hoping Jim is doing well.
|
All times are GMT -5. The time now is 04:21 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.