32 Tall water pump pulleys So today I lost a chunk of one of my pulleys. What are my options? Are new ones available anywhere ?The pumps were done by skip whilst I was on vacation about 5 years ago and work great so I am just looking to replace the pulley.
If new are not available and I can find a later 33-36 pump are the pulleys the same? Tia |
Re: 32 Tall water pump pulleys Quote:
|
Re: 32 Tall water pump pulleys Do you have the chunk? They can be brazed. Send a picture of your pulley to Skip to see if he has one that matches. [email protected] G.M.
|
Re: 32 Tall water pump pulleys Gary,
Yes, '32-'36 water pump pulleys are the same (except early '32 pulleys which were shorter from front to back) although some of the pulleys supplied for post-production service were pressed on rather than held in place on the shaft with a tapered pin. Obviously those without the holes for the tapered pin have a slightly smaller inside diameter for a press fit. There were minor differences in the pulleys in terms of casting marks (some have part numbers, some don't) and some NORS pulleys have more pronounced differences in the shape of the front part of the pulley. Dave |
Re: 32 Tall water pump pulleys Try Fryer's, (909) 335-1418. At one time they were reproducing the tall neck '32 pumps.
Charlie Stephens |
Re: 32 Tall water pump pulleys I still have a pair that I can look at to see what the pullys are like. Can compare to the 33 thru 36s which \i also have.
|
Re: 32 Tall water pump pulleys The post should have said -compare with 33 thru 36ss which I also have if that is of any help
|
All times are GMT -5. The time now is 04:08 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.