Valve clearance for 38 21 stud I’ve read a lot on how to do valve but have not found anywhere we’re a person has given the correct settings ,these are non adjustable valves!have all the tools so going old school all I need is the lash settings. ,thanks
I think I have used .012 I and .014 on ex |
Re: Valve clearance for 38 21 stud My old Motors manual say's .012I&.014EX.
|
Re: Valve clearance for 38 21 stud Thanks that’s what I’m going with !!!!!
|
Re: Valve clearance for 38 21 stud It really depends on the cam and the cam grinders specifications. If it is stock, then it is Fords specifications.
|
Re: Valve clearance for 38 21 stud In .012 Ex .014 too tight just take time grinding the stem. I made a fixture just a piece
of pipe that fits the valve stem and clamped that to the side fine grinder wheel. As I grind and rotate the valve to the wheel just nipping it check & repeat. Lash too loose, then you have to reface the valve and or the seat, to set it deeper. |
Re: Valve clearance for 38 21 stud If a standard cam I went ; int .010 -.012 exh .012 -.014 , Its been 18 months now daily driving , quiet , no problems. Spring were progressively wound and slightly heavier than stock [ Gary's one piece valve set]
|
All times are GMT -5. The time now is 12:14 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.