U-Joint rebuild Any body out there who knows how to get the spring keepers out to take a u-joint apart.
|
Re: U-Joint rebuild Can you post a picture of what you have?
Sent from my iPhone using Tapatalk |
Re: U-Joint rebuild I use a dremel tool cutoff wheel to cut the keeper in half. the new kit comes with new keepers.
|
Re: U-Joint rebuild You have to release the tension from the spring. Mount the U-joint securely in a vice and place a chisel over the center of the spring clip and give it a solid rap with a hammer. The spring clip should relax a bit, allowing you to prise it out with a sharp screwdriver or pull it out with pliers.
|
Re: U-Joint rebuild Thanks. I was trying to save the keepers, but that is a good idea
|
Re: U-Joint rebuild I made new keepers from the wire of a coat hangar. The u-joint with my homemade keepers is in my Victoria and that joint has been to 70 MPH once.
|
Re: U-Joint rebuild what is the best way to get the c clips in ?
|
Re: U-Joint rebuild I use a sharp scribe and work it in between the clip and the cup grove.
|
Re: U-Joint rebuild I tap them in with a 4 ounce ball peen hammer.
|
All times are GMT -5. The time now is 02:03 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.