rear hubs for Model A for using 39-48 hydraulics I am converting my 31 model A to hydraulics using 39-48 hubs and backing plates 12 inch drums. Is there a special rear wheel bearing for this or do I have to install the drums onto my Model A hubs ?
|
Re: rear hubs for Model A for using 39-48 hydraulics Ask in the Model A section. You use the 36 to 48 bearings. The race on the axle is the same but ID of the hub is smaller.
|
All times are GMT -5. The time now is 11:31 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.