The Ford Barn

The Ford Barn (https://www.fordbarn.com/forum/index.php)
-   Early V8 (1932-53) (https://www.fordbarn.com/forum/forumdisplay.php?f=4)
-   -   rear hubs for Model A for using 39-48 hydraulics (https://www.fordbarn.com/forum/showthread.php?t=215950)

Tom Bellfoy 03-03-2017 01:10 PM

rear hubs for Model A for using 39-48 hydraulics
 

I am converting my 31 model A to hydraulics using 39-48 hubs and backing plates 12 inch drums. Is there a special rear wheel bearing for this or do I have to install the drums onto my Model A hubs ?

redmodelt 03-03-2017 01:17 PM

Re: rear hubs for Model A for using 39-48 hydraulics
 

Ask in the Model A section. You use the 36 to 48 bearings. The race on the axle is the same but ID of the hub is smaller.


All times are GMT -5. The time now is 11:54 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.