Zenith 2 tip Rebuilding a few carbs and I came across the odd size 13/32 for the GAV assembly. removed it with a adjustable wrench, but wanted something better. Snap-on and others made a special wrench for this available on ebay etc., but it is about the only use you would have for it. Took some measurements and found that it is only a few flat file strokes away from being a 10MM. Problem fixed no extra expense. Maybe not for the purists, but works for me...
|
Re: Zenith 2 tip There was a member who made a run of 13/32 sockets for us a few years ago.
https://www.fordbarn.com/forum/showthread.php?t=160740 Bob |
Re: Zenith 2 tip Some of the crap off shore wrenches are so bad they fit right out of the cheep plastic holder.
|
Re: Zenith 2 tip What happened to the (Haag 1332) wrench? Did he decided to make a few or a large run or none? Do any of you guys know? Jack
|
Re: Zenith 2 tip I picked up an 11 mm. deep socket at Home Depot and it seems like it will do the job. Ed
|
Re: Zenith 2 tip I grab this one off Amazon. It was a little pricey, but it works well.
Martin 5/16" x 13/32" Wrench Ken |
All times are GMT -5. The time now is 01:52 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.