Carburetor confusion Ordering jets for my zenith and looking at berths i see the cap jet which it says screws into the upper casting and it shows the idle jet described as also screwing into the upper casting. But I only see one threaded hole in the upper casting aside from the center bolt hole. So which is which?
|
Re: Carburetor confusion Cap jet screws in the lower body next to the main jet.
|
Re: Carburetor confusion Buy flow tested jets not the ones that most of the suppliers push
I get them from renners corner.. If Bert's flow tests them than that's fine also |
Re: Carburetor confusion Ok, thanks
|
All times are GMT -5. The time now is 06:20 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.