Patch panels Looking for patch panels for 1956 Mercury, any recommendations ?
Thanks, Rick |
Re: Patch panels EMS! They are the best! Not sure how much they have for Mercury. Might be some of the Ford stuff will swap over.
|
Re: Patch panels Thanks, will check them out
|
Re: Patch panels EMS rockers, floor pans, inner rear quarter should fit. The front quarter and outer rear quarter are where the merc is different I think
|
Re: Patch panels From their 17 catalog they only list Merc from 41 to 48.
|
Re: Patch panels Found this new stuff by 3M, Cavity Wax, 08552 and 08551.
Wished they coated my patch panel when insatalled, now have a bit of rot under paint at horizontal, seam? |
Re: Patch panels KBS Coatings also sells a cavity wax.
I used several of their products on my 55 Victoria. https://www.kbs-coatings.com/Cavity-Wax.html Dave |
Re: Patch panels 1 Attachment(s)
Cavity wax is a must. hit all the welded seams with it too. moisture works its way in between the spot welds and rusts.
get into the rockers... there is a cowl plug in the front shoulder where the front fender bolts up. you should be able to put a 360 degree nozzle on some tubing and shoot it in there. attached is a shot of the access hole before repair. I've had my victoria done. I'll rust before it does. |
Re: Patch panels weld thru primer is a must coat the back side of patch also area your welding to
|
All times are GMT -5. The time now is 05:37 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.