Missing Cap, Inner Universal Joint Housing Here's a good one for everybody: My car is missing the Inner Universal Joint Housing!! I am wrapping up my clutch install and I was pondering the TWO universal housing gaskets... I've been driving around without this part since before i did my clutch job. It is a bit disconcerting...however it looks like the inner housing's main function is to keep the grease inside the joint and not let too much of it go down the driveshaft. Should I be safe to continue to drive it like this or should I wait until I can source the part?
Oh...anybody have one for sale? Part # A-4513-A it is the equally spaced-type spacer.... |
Re: Missing Cap, Inner Universal Joint Housing Check with Bert's Model "A" Center. 303-293-3673 www.modelastore.com
|
Re: Missing Cap, Inner Universal Joint Housing That part also keeps the rear axle from moving forward.
Bob |
Re: Missing Cap, Inner Universal Joint Housing Here is an article I di9d on the assembly if you are interested...if not...oh well!
http://www.plucks329s.org/pdf/studie...y_restorer.pdf Pluck |
Re: Missing Cap, Inner Universal Joint Housing That article was very informative. Thanks. Now if I could just find that part!
|
Re: Missing Cap, Inner Universal Joint Housing Bert's has the largest inventory of Original parts plus all the new repro parts which others carry.
They also know which repro parts are good and which not so good. |
All times are GMT -5. The time now is 07:17 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.