'32 Ford Front Fender Bolt\Screw Die
 

Does anyone make a Die to put the raised area on the fender, around the bolt holes that goes thru to the front frame horn??.....thx

Re: '32 Ford Front Fender Bolt\Screw Die
 

After making a die for myself I was told that the dimples are reproduced for Model A's.
See http://www.snydersantiqueauto.com/steel-fenders

Re: '32 Ford Front Fender Bolt\Screw Die
 

Years ago my father adapted a pipe union for a die for the dimple... sorry dont know what size he used.

Re: '32 Ford Front Fender Bolt\Screw Die
 

I got this from a thread on the HAMB. Not sure if all the info. is up to date, but you can give it a try.

32 Fender Patch

Frank Borowitz
Premier Frame & Body
3029 W. Clarendon Phoenix, AZ. 85017 602-248-0812

He also makes patches for the front fenders of a 32 where screws go though to the frame in front

Keep V-8ing and 4-banging!

Re: '32 Ford Front Fender Bolt\Screw Die
 

Frank makes anything,Good Man

Re: '32 Ford Front Fender Bolt\Screw Die
 

Thanks for the lead on Frank Borowitz. I called today, but the phone was disconnected.

Re: '32 Ford Front Fender Bolt\Screw Die
 

Zeke,

Try this number: (602) 267-1319

Keep V-8ing and 4-banging!

Re: '32 Ford Front Fender Bolt\Screw Die
 

If you know someone with a metal lathe it is not difficult to make a pair of dies having a thru-bolt to pull them together. Receiver die on top, pusher below--make them out of scrap mild steel. Slick solution.