1936 spare cover trim clips
 

A while back there was a discussion about where to find 36 spare cover stainless trim clips. I can't seem to dredge it up.
Anyone know where I can find some or something that will work?

Re: 1936 spare cover trim clips
 

I've got some, email me.

Re: 1936 spare cover trim clips
 

John, Here is a picture of an original and Auveco replacement

Re: 1936 spare cover trim clips
 

How many clips per ring?

Very popular post. I have 4 responses already and my ring/clips weren't even for sale!
I have 15 clips in Rust 911. I should know by tomorrow how many are good. Seems to me the motivated restorer could make some by welding a small bolt to a strip of sheet metal the correct width.

I see Macs lists the ring and clips as discontinued. Lucky I got mine when I did!

Re: 1936 spare cover trim clips
 

Takes 9.Couldn't find any so I made mine from tiny rivet nuts that Drake sells.Southside Obsolete in MN might have some originals.
Here is a pic of what I did and it worked for me.I ground down the head. Drake part number 1160-R.

Re: 1936 spare cover trim clips
 

I have found that the reproduction trim ring needs to be installed using the clips provided. Stock clips will not fit, since the reproduction ring is more narrow than the stock ring. Since the reproduction trim rings are no longer in stock, good original rings are out there, but getting harder to find in good condition.

Re: 1936 spare cover trim clips
 

I've got a good original ring and 9 original clips for sale in the want ads https://fordbarn.com/forum/showthread.php?t=263268

Re: 1936 spare cover trim clips
 

Just measured 0.38 original vs 0.35 repro width on the outside.

Re: 1936 spare cover trim clips
 

Looking for rings and clips....any suggestions?

Re: 1936 spare cover trim clips
 

My clips and ring are sold. Watch ebay

Re: 1936 spare cover trim clips
 

I live on ebay, only see the rings on old spare tire covers, I actually have a beat up one I could use but still need some clips, was considering silicone or gorilla glue as a last resort since mine isn't pristine :confused:

Re: 1936 spare cover trim clips
 

Re: 1936 spare cover trim clips
 

Update;
I was able to remove the donor spare tire cover trim and salvage 6 original 80+ yr old clips! Installed it on my tire cover and they held w/the 6 I have. Until I can find a better replacement trim molding in better condition this one will work.

Re: 1936 spare cover trim clips
 

I may have a ring that I can sell. I will have to measure the width as it is still wrapped in protective paper when I had it repaired and polished. I have not looked at them lately as I had some '34's and '36's done years ago. Email me at [email protected] if you are interested.

Re: 1936 spare cover trim clips
 

I sent you an email yesterday for this ring if you have it...imagine others did too? PLMK