Looking for a line-boring jig for a model A ford City:
Terre Haute
State:
Indiana
Hello,
I have a line-bore machine , but need the jig used to align the boring bar in newly poured babbitt in the mains in Model A and B Fords, the machine that I have is a Serv-Equip {looks like a van-norman LB3200} I think the alignment jigs from a Tobin-Arp machine will work .These jigs fit into the cam bearing hole and rest on the oil pan rail, leaving a hole to place the boring bar in , or to indicate off of thanks for looking JIMI |
Re: Looking for a line-boring jig for a model A ford still looking
|
Re: Looking for a line-boring jig for a model A ford one last time to the top
|
All times are GMT -5. The time now is 09:01 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.