Gravity bends a crank? I had my crank reground 4 or 5 years ago and put it in a box to store it. the box is resting on the floor and the crank inside is parallel to the floor. Is there any truth that all crankshafts should be store vertically?:confused:
|
Re: Gravity bends a crank? Quote:
|
Re: Gravity bends a crank? agreed, there is truth to this, if it is not properly supported while being stored horizontally.
|
Re: Gravity bends a crank? This is one of the topics that there is little agreement on, but most believe that the sagging crank theory is a myth. Easy enough to check, run a gauge on it and see what you have.
|
Re: Gravity bends a crank? I'm concerned now... Will climate change bend my crank?
|
Re: Gravity bends a crank? No, but if global warming causes the seas to rise enough to flood Salt Lake City, it will rust.
|
Re: Gravity bends a crank? Well OK then. I will rotate the box 180* and wait another couple of years. If it is sagging this should fix it.
|
Re: Gravity bends a crank? Uncle max, The coefficient of thermal expansion of steel is such that unless the extreme temperature is sustained, thereby not permitting the crank to return to its nominal size, the distortion will remain. At least that's my view.
Think of a rail road track expanding during summer and contracting during winter. I just realized you are joking? |
Re: Gravity bends a crank? on larger (non-automotive) engines, you have jacking gear to turn them over slowly after they have been sitting for a while to remove any distortion from gravity, and this is a crank that is supported. no doubt in my mind that same doesn't happen to an unsupported one. the question becomes what is tolerable. may never even notice it? i can't answer that. but i have to believe that there is measurable change there. if it were a 9000 rpm racing engine, there is probably something to be worried about. these engines, maybe not.
|
Re: Gravity bends a crank? Quote:
|
Re: Gravity bends a crank? I would think that if gravity bends a crank laying on its side too long that standing it on end too long will cause its diameter to spread. . . kinda like my diameter has spread from standing on my end too many years. :rolleyes:
|
Re: Gravity bends a crank? Quote:
|
Re: Gravity bends a crank? I had to look that one up, Alan. DD
|
Re: Gravity bends a crank? Quote:
|
Re: Gravity bends a crank? I got 'er figured-out......had just never seen that one before. What the heck do I know? DD
|
Re: Gravity bends a crank? I have always been amazed at discussions like this. Here's a crankshaft that can take the firing impulses running in an engine for 90-100K miles, and some prople wwill think it will bend sitting on a floor? Give me a break!
|
Re: Gravity bends a crank? Quote:
|
Re: Gravity bends a crank? Quote:
Perhaps it the tab was over a foot then with time it could sag under its weight, and long distance to its connection to the shaft! |
Re: Gravity bends a crank? Quote:
|
Re: Gravity bends a crank? Molly Cules...she worked at the cafeteria next to the crankshaft foundry at the Rouge plant. Was said to have inspired the workers to make sure their crankshafts were always straight, even if they were laid flat.
|
All times are GMT -5. The time now is 03:46 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.