Axle tapper Can one of you fellas tell me what the tapper specs. are on the hub end of a model A rear axle? Also what is the diameter of the rest of the axle? I don't have one that is accessible to use as a pattern but am needing to make a short stub shaft to go in the lathe. Thanks
|
Re: Axle tapper 5/8" -18 threads on axle hub end, I believe.
|
Re: Axle tapper 4 degrees should do it starting at 29mm cheers
|
Re: Axle tapper Hello all, I'm new to the "Barn" but old with "A's". I'll do a proper introduction when I get more time.
As for the OP ? … I'm looking at a section of axle shaft, measures 1.165" dia.... or 29 and some mm in OZ Joe B |
All times are GMT -5. The time now is 05:57 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.