30 model A trunk lid conversion question Converting my rumble seat to trunk. Need bolt location on trunk lid to mount the hinge bracket. It appears the trunk lid normally has an indent with associated mounting holes. The rumble lid has none. Any help would be appreciated. Thanks
|
Re: 30 model A trunk lid conversion question Try advertising for someone that wants to swap. Everyone seems to want a rumble seat but having gone that route I wish I had a trunk.
Charlie Stephens |
Re: 30 model A trunk lid conversion question ..
Please read the RESTORER January/February 2016 Ray Horton did a 4 page write-up on it. |
Re: 30 model A trunk lid conversion question Quote:
You also might want to check these out: http://www.plucks329s.org/pdf/studie...%20PART_1A.pdf http://www.plucks329s.org/pdf/studie..._Part_%202.pdf http://www.plucks329s.org/pdf/studie..._Part_%203.pdf Pluck |
Re: 30 model A trunk lid conversion question I appreciate the feedback and have read the article regarding the conversion but it does not give the location of the support bracket mounting bolts on the trunk lid. May just have to wing it!
|
Re: 30 model A trunk lid conversion question The holes for the holder/upper bar, are not TOO CRITICAL.
It "might" be easier, to just trade your car for one with a TRUNK. Cars with TRUNKS, should command a higher selling price. GRUMBLE SEATS are a pain in the ASS! Bill Cargo |
All times are GMT -5. The time now is 08:20 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.