Tillison and Marvil carb Does any one have float setting for tillison and marvel carbs thanks Richard
|
Re: Tillison and Marvil carb |
Re: Tillison and Marvil carb |
Re: Tillison and Marvil carb 1 Attachment(s)
Depends on type!
|
Re: Tillison and Marvil carb For the Tilly, use 1". with upper half turned up side down, measure from gasket surface to top of float.
for Marvel, 15/16" with upper half turn up side down, measure from gasket surface to float seam, and the seam should be level to the gasket surface. Hope this helps. |
Re: Tillison and Marvil carb Thanks
|
All times are GMT -5. The time now is 05:33 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.