The Ford Barn - Help ID hood trim please

The Ford Barn (https://www.fordbarn.com/forum/index.php)

- Early V8 (1932-53) (https://www.fordbarn.com/forum/forumdisplay.php?f=4)

- - Help ID hood trim please (https://www.fordbarn.com/forum/showthread.php?t=277287)

Kube	02-27-2020 04:44 PM

Help ID hood trim please

1 Attachment(s)

Guys, I could use some help here please.

All four pieces are about 1/2" wide.
The two short pieces are each about 33 1/2" long and have speared ends.
The two long pieces are about 51 1/2" long and have one spear end and one "flat' end.

What say you?

Thanks.

alanwoodieman

02-27-2020 04:53 PM

Re: Help ID hood trim please

on the flat end are they slanted? look like 39 deluxe hood trim but maybe zepher ??

Kube	02-27-2020 04:55 PM

Re: Help ID hood trim please

Quote:

Originally Posted by alanwoodieman (Post 1856573)

on the flat end are they slanted? look like 39 deluxe hood trim but maybe zepher ??

Alan, There's a slight slant as you suggest.
I thought 39 deluxe trim was just a tad wider. No? Maybe about 5/8". I wish I had a car close by to compare.
What ya think?

30six

02-27-2020 08:34 PM

Re: Help ID hood trim please

Mike: Look on Ebay. There is currently a 39 Deluxe hood with trim that looks like your photo.

mercurycyclone

02-27-2020 09:40 PM

Re: Help ID hood trim please

2 Attachment(s)

Mike the I measured a pair of lower 39 Deluxe Ford hood moldings and I get about 34 15/16” x 5/8” see attached.

Kube	02-27-2020 10:11 PM

Re: Help ID hood trim please

Quote:

Originally Posted by mercurycyclone (Post 1856686)

Mike the I measured a pair of lower 39 Deluxe Ford hood moldings and I get about 34 15/16” x 5/8” see attached.

I thought the deluxe trim was about 5/8" wide. Thanks. I think I can eliminate 39 deluxe for this stuff.

All times are GMT -5. The time now is 11:46 PM.