8RT Oil Pan and starter plater I have a 8RT starter plate and pan on my 8BA. I went on Van Pelts site and I'm missing some pieces. The main part is 8RT-6410 which looks like it bolts up to the block. Is that correct? Is this part and all the seals & bolts available?
Thanks, Joe |
Re: 8RT Oil Pan and starter plater 3 Attachment(s)
It does bolt up into the block. The 2 long bolts replace the 2 normal pan bolts straddling the rear seal. 6410 is NLA, as far as I know, but the rubber seals that it carries (to shield the short section of crank behind the seal in the pan) are available, I think from Mac VP.
|
Re: 8RT Oil Pan and starter plater Quote:
Anybody got one??!! |
Re: 8RT Oil Pan and starter plater We have the 6410, the 6424, and the 6425.......all are sold separately.
|
Re: 8RT Oil Pan and starter plater Quote:
|
Re: 8RT Oil Pan and starter plater Anyone have the bolts or an idea for a replacement?
|
Re: 8RT Oil Pan and starter plater I'd start at the local hardware store.
|
Re: 8RT Oil Pan and starter plater Does anyone know the thread size?
|
Re: 8RT Oil Pan and starter plater 5/16"nc, 3/4" longer than the holes in the shield should be right.
Terry |
Re: 8RT Oil Pan and starter plater Thanks Overkill!
|
All times are GMT -5. The time now is 04:27 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.