16 spline Slip yoke I converted a 40 3 speed to an open driveshaft. Now I need a 16 spline slip yoke. I know it's been asked before, but never found a good answer. What years should I look for? Or where can I buy a new one. Some of the places I looked on the net were confusing. Does anybody have a link I can go to, even if it's E-Bay.
Thanks in advance, :) Dennis https://photos.smugmug.com/Cars/Bobs...13171611-M.jpg |
Re: 16 spline Slip yoke H;i the original yokes are usually with the driveshafts,use a pressed in u joint. I have heard of a GM yoke that will work. the yoke is fixed by a bolt into the output shaft right? Others will jump in on this post. Newc
|
Re: 16 spline Slip yoke I just picked up a NOS yoke from "barnfind08", contact him and see if he has another.
|
Re: 16 spline Slip yoke 1955 to 61 GM cast iron powerglide yoke.
|
Re: 16 spline Slip yoke 55 chev. power glide yoke will work .. A little longer but can be trimmed . I think the original is about an 1" shorter. I can check my pile and look when I get out in the shop .. Not too hard to locate for you I would think. Van
|
Re: 16 spline Slip yoke Thanks. Can you post a picture of it when you find it?
|
Re: 16 spline Slip yoke The 21C-4841 was the first knuckle & plug (or slip yoke) for the open drive commercials and it was used from 1942 to 1952. It should be relatively common, especially when folks are swapping out the Dana Spicer stuff for something else.
|
Re: 16 spline Slip yoke I got one if your still looking. $45 shipped to your door. Its out of a 50 ford F1
|
Re: 16 spline Slip yoke Do you still have your 50 F1 16 spline slip yoke?
|
Re: 16 spline Slip yoke Quote:
|
Re: 16 spline Slip yoke I think manual customline one fits
|
Re: 16 spline Slip yoke We stock them.....it’s made to fit the regular passenger car transmission but will fit the short pickup trans like you have by trimming it down about an inch and a half. They have the same knuckle set up as the original Ford pickup driveshaft did.
|
All times are GMT -5. The time now is 02:24 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.