Crankshaft Tool Does anyone know where I can get one of the tools to turn crankshaft when engine is sitting vertical when aligning flywheel housing?? Anyone have one for sale??
|
Re: Crankshaft Tool 1 Attachment(s)
The vendors have them. https://www.snydersantiqueauto.com/P.../model-a/tools
|
Re: Crankshaft Tool A good start but would need to be modified for dial indicator to be centered. Could cut out the center nut and weld a couple of half inch 90 degree pipe fittings on the outer edges for extension handles. Thanks, may give this a try.
|
Re: Crankshaft Tool You could try one of these bad boys... a little more expensive. https://www.snydersantiqueauto.com/P...earchByKeyword or make your own out of an old starter.
Or use a 1⅜"wrench on the ratchet nut on the other end of the crank. |
Re: Crankshaft Tool 1 Attachment(s)
Is this what your looking for??
|
Re: Crankshaft Tool Bob, who made that exactly? If, we ever get back to a swap season that's on my list. Thinking KR Wilson?
|
Re: Crankshaft Tool Krw a320
|
Re: Crankshaft Tool Quote:
|
Re: Crankshaft Tool What's wrong with just using a socket on the crankshaft pulley nut?
|
Re: Crankshaft Tool Quote:
|
All times are GMT -5. The time now is 06:07 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.