manifold stud washers Which way does the concave manifold washer go? Thanks, Carl
|
Re: manifold stud washers Crown goes to the outside - toward the nut
|
Re: manifold stud washers |
Re: manifold stud washers Concave side always faces in, so the nut puts pressure to the high center of the washer.
|
Re: manifold stud washers 1 Attachment(s)
Quote:
If the thickness on the two manifolds are different the washer tilts. With the high side towards the nut it "compensate" for this tilt. In the picture below all the elements are the same size, the curved "washer", the black boxes are the manifolds, and of course the nuts. |
All times are GMT -5. The time now is 05:49 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.