1931 1932 1933 BB Big Truck Help
 

Okay. I am hopeful there are some folks here who can help me.

I have a big truck I trying to save from the recycler. It is a 1932 SWB truck. I also acquired a 33 LWB chassis. I also have some Model A components. 32 Front end was bent so replaced with 33. The 32 rear is in place. Tranny is from the 33. Bolted up to the 32 Bell and Model A Motor (4cyl). Thought all was good but flywheel rubs on something, Maybe the starter (also A) Or something else. I can take pics to help ID this all and I have other parts that were part of years of pickin. Need some guidance and share what works.

Thanks in advance!

Dennis

Re: 1931 1932 1933 BB Big Truck Help
 

Rubbing? I seen a share of the ring gear not seated and rubbing on the block...
got to heat it and seat it till it registers.

Re: 1931 1932 1933 BB Big Truck Help
 

What flywheel housing are you using? If you have a B pan and flywheel
housing you need a B flywheel. Also if the starter bolts are to long they can
rub the flywheel.

Bob

Re: 1931 1932 1933 BB Big Truck Help
 

Check the starter bolts. I've used standard bolts out of the bin before and they were too long.

Re: 1931 1932 1933 BB Big Truck Help
 

I'll do that. Thanks. Will report - Dmac

Re: 1931 1932 1933 BB Big Truck Help
 

Any chance you have a Model A flywheel? They will rub the later transmission cases? Can you get a picture?

Charlie Stephens