21 stud temp gauge question Does the temp gauge bulb just screw into the waterpump? No special fitting? It looks like there is a tapered shoulder in the hole but not sure.
|
Re: 21 stud temp gauge question The temp gauge used in these 21 stud engines is the capillary type; has the glass tube with red liquid. Yes, it seats on that tapered shoulder you refer to. The thread is 5/8 UNF. The later 24 stud engines use the electric type temp gauges. These screw into the heads with a 3/8 pipe thread. Will not fit the earlier engines
|
Re: 21 stud temp gauge question Used one like this gauge on my '34 21 stud. No special fitting required...
https://i.ebayimg.com/images/g/dzEAA...Nmw/s-l400.jpg |
Re: 21 stud temp gauge question Ok thanks guys. I am running an aftermarket mechanical gauge and it looks correct I just was not sure if the waterpump needed a special fitting.
|
Re: 21 stud temp gauge question mine is in top radiator jose..sc
|
All times are GMT -5. The time now is 08:48 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.