32 PU model B windshield wiper motor ? Did a seach for original 32 PU "B" wiper motor did not find much info..would like to lnow what I should be looking for..I want original style ? what was available at factory out the door ..not interested in modern Chink junk..sc
|
Re: 32 PU model B windshield wiper motor ? You should find this thread in the archives interesting. https://www.fordbarn.com/forum/showt...=b%2A17508%2Af
The title of the thread is: 1932 Model B pickup wiper motor Charlie Stephens |
Re: 32 PU model B windshield wiper motor ? I see a KSL 230 looks just like 32 comm but it says 30-31 model A ..are they the same ?? how about KSL 511 is that the correct motor for 32 B PU ?
|
Re: 32 PU model B windshield wiper motor ? Re-read the earlier thread as Charlie has suggested and you will note that KSL511 is not the correct wiper motor for a '32 pickup.
I admit that it is a bit confusing that the wiper motors are stamped with Trico's part numbers rather than or in addition to Ford's part number. I suspect that there are a lot fewer surviving Trico catalogs of the period than Ford catalogs. May be someone herein with a Trico catalog can provide the Trico number (other than KSL 511). |
Re: 32 PU model B windshield wiper motor ? Here is a link to an ad placed here.In the second pic lower left looks like a 32-34 commercial wiper motor.
https://www.fordbarn.com/forum/showthread.php?t=254914 |
Re: 32 PU model B windshield wiper motor ? I agree that it would likely do the job with a couple of alterations. The on/off control on an original was shorter and the back of the shaft did not protrude through the rear cover. The shaft can be easily shortened and the rear cover replaced with one without a hole for a protruding shaft. The rear covers are the same for nearly all late '32-'34 wiper motors (all of which do not have a hole in the cover).
|
Re: 32 PU model B windshield wiper motor ? I happen to have a few (3)deep 32 (2 screw attachments) and (4) of the 33 up shallower rear covers - all left over.Free- just pay postage.
|
All times are GMT -5. The time now is 07:35 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.