40 Pickup Set Screw Size for Hinge Pin Mirror These set screws are bigger on the truck than on the car - just looking for the size.
Anyone one use the car hinge pin mirrors on the pickup? Looks like it would need a spacer to get the set screw to line up ..... Thanks for any help you can give ..... |
Re: 40 Pickup Set Screw Size for Hinge Pin Mirror The passenger car mirror will not work on the pickup or vice versa. The pickup hinges and passenger car hinges are not the same width.
|
Re: 40 Pickup Set Screw Size for Hinge Pin Mirror Thanks for the response ..... Roger on the hinge mirror arms - do you know the pickup set screw size?
|
Re: 40 Pickup Set Screw Size for Hinge Pin Mirror The ones on my 41 pickup mirrors were 1/4X20.
|
Re: 40 Pickup Set Screw Size for Hinge Pin Mirror Quote:
|
Re: 40 Pickup Set Screw Size for Hinge Pin Mirror Thanks!
|
Re: 40 Pickup Set Screw Size for Hinge Pin Mirror Quote:
So now, having the answer you sought, you make the investment in time and money to travel to your nearest hardware store to purchase a nice stainless steel 1/4x20 set screw, only to find that for some unexplained reason, yours isn't 1/4x20 as expected. Who ya gonna blame? :D |
Re: 40 Pickup Set Screw Size for Hinge Pin Mirror No where near 1/4-20 - must have been retapped or maybe the cab is off a big truck? Bought the cab many years ago as a single and separate item and it’s origin is uncertain .....
|
Re: 40 Pickup Set Screw Size for Hinge Pin Mirror Is it bigger or smaller than 1/4X20?
|
Re: 40 Pickup Set Screw Size for Hinge Pin Mirror Bigger - 5/16-20 was too small as well .....
|
Re: 40 Pickup Set Screw Size for Hinge Pin Mirror Wow, that must be something off a big truck. I've never seen one bigger than 1/4X20.
|
Re: 40 Pickup Set Screw Size for Hinge Pin Mirror Tom, on my white pickup (1941) the tapped hole in the hinge is 5/16 UNF. (5/16-24).
The bolt on my truck (I think set screw is the right term) is threaded all the way up and the thread is 1" long. Mart. |
Re: 40 Pickup Set Screw Size for Hinge Pin Mirror Thanks Mart - I will check it today ....
|
Re: 40 Pickup Set Screw Size for Hinge Pin Mirror Quote:
|
Re: 40 Pickup Set Screw Size for Hinge Pin Mirror Thanks Kube - just saw this .....
|
All times are GMT -5. The time now is 09:03 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.