clutch plate i have a pin on clutch plate that is stuck down and the clutch finger has a lot of play can i take out the clutch housing bolts to the brake drum so see the damage i do not have the time to pull the engine out and the rear end right now
|
Re: clutch plate Removing the hogs head can be a bear. Some depends on whether it has a starter or not. The top will come off but other things may need to be removed or moved out of the way to get it off & back on again. I don't know if it will allow much disassembly though. This is one persons procedure. There are likely others too.
http://www.mtfca.com/discus/messages...tml?1348584247 |
Re: clutch plate |
Re: clutch plate My motto is : if you don't have time to do it right, when will you find time to do it over?
|
Re: clutch plate I re-read your post, and if I am understanding your problem correctly, the engine-trans will have to come out and the trans will have to be disassembled at least the rear plate that holds the 3 fingers will have to be removed.
|
All times are GMT -5. The time now is 07:09 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.